Application
Additional clamping point set up when fixture already clamped.
Clamping point set up subsequently when machine table T-groove already occupied.
Insert the "Rhombus" T-groove nut into the T-groove from above and turn it until it stops in the T-groove.
Use in conjunction with stud screws to DIN 6379.

Execution
Tempered

Notes
The nuts for "Rhombus" T-grooves are heat treated to grade 10.
Due to the reduced contact surface in the T-groove, the load capacity is lower than for the comparable sizes to DIN 508.
The screw connection must be made over the entire thread length "h1".